ZHCSKL7 December 2019 – December 2019 TCAN1044V
PRODUCTION DATA.
- 1 特性
- 2 應用
- 3 說明
- 4 修訂歷史記錄
- 5 Pin Configuration and Functions
-
6 Specifications
- Table 1. Absolute Maximum Ratings
- Table 2. ESD Ratings
- Table 3. ESD Ratings
- Table 4. Recommended Operating Conditions
- Table 5. Thermal Characteristics
- Table 6. Supply Characteristics
- Table 7. Dissipation Ratings
- Table 8. Electrical Characteristics
- Table 9. Switching Characteristics
- 6.1 Typical Characteristics
- 7 Parameter Measurement Information
-
8 Detailed Description
- 8.1 Overview
- 8.2 Functional Block Diagram
- 8.3 Feature Description
- 8.4 Device Functional Modes
- 9 Application and Implementation
- 10Power Supply Recommendations
- 11Layout
- 12器件和文檔支持
- 13機械、封裝和可訂購信息
封裝選項
機械數據 (封裝 | 引腳)
- DDF|8
散熱焊盤機械數據 (封裝 | 引腳)
訂購信息
8.3.2 CAN Bus States
The CAN bus has two logical states during operation: recessive and dominant. See Figure 12 and Figure 13.
A dominant bus state occurs when the bus is driven differentially and corresponds to a logic low on the TXD and RXD pins. A recessive bus state occurs when the bus is biased to VCC/2 via the high-resistance internal input resistors (RIN) of the receiver and corresponds to a logic high on the TXD and RXD pins.
A dominant state overwrites the recessive state during arbitration. Multiple CAN nodes may be transmitting a dominant bit at the same time during arbitration, and in this case the differential voltage of the bus is greater than the differential voltage of a single driver.
The TCAN1044V transceiver implements a low-power standby (STB) mode which enables a third bus state where the bus pins are weakly biased to ground via the high resistance internal resistors of the receiver. See Figure 12 and Figure 13.
Figure 12. Bus States -and-Receiver.gif "TCAN1044V Simplified Recessive Common Mode Bias Unit and Receiver")