ZHCSLQ0B August 2020 – November 2023 TCA4307
PRODUCTION DATA
- 1
- 1 特性
- 2 應用
- 3 說明
- 4 Pin Configuration and Functions
- 5 Specifications
- 6 Parameter Measurement Information
- 7 Detailed Description
- 8 Application and Implementation
- 9 Device and Documentation Support
- 10Revision History
- 11Mechanical, Packaging, and Orderable Information
封裝選項
機械數據 (封裝 | 引腳)
散熱焊盤機械數據 (封裝 | 引腳)
- DRG|8
訂購信息
8.2.2 Detailed Design Procedure
The system pull-up resistors must be strong enough to provide a positive slew rate of 1.25 V/μs on the SDA and SCL pins, in order to activate the boost pull-up currents during rising edges. Choose maximum resistor value using the formula given in Equation 1.
where R is the pull-up resistor value in ?, VCC(MIN) is the minimum VCC voltage in volts, and C is the equivalent bus capacitance in picofarads (pF).
In addition, regardless of the bus capacitance, always choose RPU ≤ 65.7 k? for VCC = 5.5 V, RPU ≤ 45 k? for VCC = 3.3 V, and RPU ≤ 33 k? for VCC = 2.5 V. The start-up circuitry requires logic HIGH voltages on SDAOUT and SCLOUT to connect the backplane to the card, and these pull-up values are needed to overcome the pre-charge voltage.