4 Revision History
Changes from Revision B (January 2017) to Revision C (May 2023)
- Added Additional manufacturing certification pending to
Safety-Related Certifications tableGo
Changes from Revision A (September 2015) to Revision B (January 2017)
- 將數據表標題從有源安全特性 更改為有源保護特性
Go
- 將“特性”從“浪涌抗擾度為 12800VPK（根據 IEC 61000-4-5）”更改為“可承受的隔離浪涌電壓 12800VPK”Go
- Changed the minimum external tracking (creepage) parameter to the external creepage parameterGo
- Changed the input-to-output test voltage parameter to the apparent charge parameterGo
- Added the climatic category to the Insulation Specifications tableGo
- Changed the CSA status from planned to certifiedGo
- Added text ", but connecting CLAMP output of the gate driver to the IGBT gate is also not an issue." to Supply and Active Miller Clamp
Go
- Changed the second paragraph of the Typical Applications
Go
- Added text "and
RST input signal" to the Design Requirements
Go
Changes from Revision * (July 2015) to Revision A (September 2015)
- 將特性 部分的“100kV/μs 最小共模瞬態抗擾度...”移至列表頂部Go
- 將首頁的“產品預發布”更改為完整數據表Go
- 將說明 中的文本“3V 至 5.5V 的單電源”更改為“2.25V 至 5.5V 的單電源”Go
- 將說明 中的文本“IGBT 處于過載狀態”更改為“IGBT 處于過流狀態”Go
- 將說明 中的文本“并在最短 2μs 的時間跨度內降低 OUTL 上的電壓”更改為“并在 2μs 的時間跨度內將 OUTL 拉至低電平”Go
- 更改了功能方框圖，在引腳 OUTL 上添加了 STOGo
- 更改了說明 的第 3 段Go
- Changed the minimum air gap (clearance) parameter to the external clearance parameterGo